What does 9 beeps mean?
ROM BIOS Checksum Failure
Troubleshoot CPU, motherboard. 8 Beeps – Display Memory Failure. Trouleshoot graphics card, motherboard. 9 Beeps – ROM BIOS Checksum Failure. Replace ROM BIOS, troubleshoot motherboard.
Why is my HP Pavilion beeping?
4 Answers. Beep sounds typically occur when a keyboard key is stuck, a memory DIMM or hard drive cable is not seated properly, or a component on the motherboard has failed. Disconnect the mouse and keyboard, and then restart the computer. If the beeping noise stops, repair or replace those devices.
Why is my HP monitor beeping?
The most common problems that cause beeping sounds are: Memory and heat-related failures caused by a build-up of dust in critical cooling areas. A keyboard key is stuck. A memory DIMM or hard drive cable is not seated properly.
Why does my hp dc7700 Beep nine times?
The computer beeps nine times and the power LED blinks red nine times during startup. Ensure the voltage selector located on the rear of the power supply is set to the appropriate voltage. Reseat the processor. Replace the system board. For more information, see the HP Compaq dc7700 Business Desktop PC Service Reference Guide, 1st Edition.
Is it normal for a HP computer to make a beep?
This document pertains to HP and Compaq Desktop PCs. It is normal for the computer to make one or two short beeps during the startup process or during a BIOS update. Let the process continue and do not interrupt it.
How to Fix HP Compaq dc7700 desktop PC?
Ensure the voltage selector located on the rear of the power supply is set to the appropriate voltage. Reseat the processor. Replace the system board. For more information, see the HP Compaq dc7700 Business Desktop PC Service Reference Guide, 1st Edition. Loading… Loading… Loading… Loading…
How can I tell if my computer is beeping?
Listen to the beeping sound and write down the number of beeps before each pause, if the beeps are long or short, or if the beeps high or low in tone. Once a pattern is determined, use the following beep code table to identify which component might be causing the problem: note: Not all beep codes are shown.
