How do you change the rear brake pads on a Mercedes E320?

How do you change the rear brake pads on a Mercedes E320?

How to change/replace rear brake pads on 210 E-Class E320

1. Set the emergency brakes.
2. Open the hood and remove the cap from the brake fluid reservoir.
3. Remove the rear wheels from your Mercedes-Benz W210 E320.
4. Remove the brake pad wear sensor from the right brake pad.

How much does it cost to replace brake pads on a Mercedes-Benz?

Brake pads for a Mercedes-Benz can cost anywhere between $150 per axle and $450 per axle depending on the type of brake pad desired. Mercedes-Benz Brake rotor replacement can cost anywhere between $300 – $750 for all four rotors to be replaced. This price estimate includes labor and components.

How much are brakes for a Benz E320?

The average cost for a Mercedes-Benz E320 brake pad replacement is between $201 and $230. Labor costs are estimated between $110 and $139 while parts are priced at $91.

How do you replace brake pads on a Mercedes W210 e320?

Remove the rear wheels from your Mercedes-Benz W210 E320. Remove the brake pad wear sensor from the right brake pad. Use a hammer to remove the pin that holds the brake pads in place. As you extract the retaining pin be careful to not hit the brake heat shield. If you hit the shield you may bend it and cause it to make noise when you drive.

When did the Mercedes E class brake pads come out?

This article applies to the Mercedes-Benz E-Class w211 (2002-2009). Few parts on your Mercedes-Benz are as important as your brake components. And with a high-performance luxury vehicle like the E-Class, fast driving requires even faster braking.

How do you replace the caliper on a Mercedes Benz?

Pull the caliper off the caliper bracket, and support it with a hook or wire to avoid hanging it from only the brake line. Then, use a small drill bit to remove two stabilizer pins on the caliper bracket. Insert a flat head screwdriver between the brake pads and the caliper bracket.

How do you replace brake pads on a clk350?

Remove the old brake pads and clean the area where the brake pads make contact with the caliper. Install the new brake pads. Apply brake grease on the area where the brake makes contact with the caliper. Install the retaining pin. Make sure to align the brake pads and install the pin by hammering it in. Install the wheel and lower the car.