What does F08 mean on a Maytag washing machine?
The error code means that your washing isn’t detecting the water coming into your machine. The flow meter is detecting the water that is coming into your machine isn’t an adequate pressure or flow.
What does F08 mean on a washing machine?
open circuit
F08 indicates that the heater is an open circuit so check the heater for continuity with a meter.
What does E02 mean on Maytag washer?
The F0 E2 or Sd error code means your washer has detected an excessive amount of suds in the washer basket. The washer will run an automatic suds reduction routine, to try to eliminate most of the excess sudsing. Allow the washer to continue to run.
What does F08 error mean?
This is info i had come up with, F08 indicates that the heater is an open circuit. Check the heater wires for dislodged or burnt wires and check the heater for continuity with a meter. Check the link below for further info.
What does F8 E1 mean on a Maytag washer?
F8 E1 or LF or LO FL Error Code in the Display of my Maytag Washer. Error Code F8 E1, LF, or LO FL all indicate that no water is detected entering washer after 13 minutes. Depending on your model, you could see any one of these error codes. See your Owner’s Manual for further assistance.
What does F08 mean on a whirlpool washing machine?
In most cases, the designation F08 occurs precisely when the heater fails. If this is really the case, you must replace the part with a new one. But the failure of the heater is not the only reason for the appearance of such an error. Code may mean something else.
What does code E02 F08 mean on Maytag maxima?
This video shows what to look for and how to fix your Maytag Maxima (mhw6000xw) front oading washing machine when it gives the code E02 F08. This code means something is wrong with the dispenser. Many models share the same dispenser setup such as the Whirlpool Duet, but they may give a different error code about the dispenser.
How to remove error code from Maytag washer?
Make sure to open both faucets completely for proper fill. NOTE: Both Hot and Cold water must be supplied to the washer. To remove the error display, press Power once. Then press Power again to restart the washer. Unplug the washer or disconnect the power for one minute.
