How do you read a ceramic capacitor value?

How do you read a ceramic capacitor value?

Ceramic disc capacitor code / label will normally consist of three numbers followed by a letter. They are very easy to decode to find the value. The first two significant digits represent the first two digits of the actual value, which is 47. The third digit is the multiplier, which is ×1000.

What is J and K in capacitor?

A capacitor that has a decimal is typically measured in uF. For example: .47 = .47 uF = 470 nF. The letter on a capacitor designates the tolerance. J = +/- 5% K = +/- 10%

Where is the value of a capacitor marked?

The value of the capacitor is denoted in picofarads for ceramic, film, and tantalum capacitors, but for aluminium electrolytic capacitors the value is denoted in microfarads. For small values the letter R is used to denote a decimal point, e.g. 0R5 is 0.5, 1R0 is 1.0 and 2R2 is 2.2, etc..

How do I find the value of a SMD capacitor?

How to test a SMD capacitor?

1. Step1 – Remove your capacitor from the PCB ( it is not possible to test the component without removing it from the board)
2. Step2 -Put your multimeter to the Mega-ohm range.
3. Step3 – Now observe the value Of the component,

Would a capacitor labeled 470k be 47pf or 470pf?

If it’s a K labeled capacitor, the chances that anyone would label a 471 as 470 are small. 470 10% on a small can might be 470pF, but 470K is 47pF. According to this site, 470k would be 47pF… In general, on those small, rounded, ceramic capacitor, you don’t have too much space to write.

Where to find tolerance code on ceramic capacitor?

Read the tolerance code on ceramic capacitors. Ceramic capacitors, which are usually tiny “pancakes” with two pins, typically list the tolerance value as one letter immediately after the three-digit capacitance value.

How can I read the number 47 on a capacitor?

If the surface of the body is large enough, the value will be printed directly on the capacitor. For example, 47 uF indicates 47 microFarads. Read the capacitance of smaller bodied capacitors as two or three numbers. The designators uF or pF will not appear due to the small size of the capacitor body.

How to read the markings of a capacitor?

The brown capacitors have values in picoFarads eg 47 = 47 picoFarad = 47 pF = 0.000 000 000 047 Farad ! 10 = 10 pF For the yellow and green capacitors with markings of the form anb Here n = nanoFarad = nF. 1n0 = 1.0 nF 2n2 = 2.2 nF 6n8 = 6.8 nF